It never needs to be as hard as you thought to add driving lights. The page layout of your drive, its building and how you want the street lenses spread along the drive depend on how difficult it will. Installing driveway lights will be the very first thing to do by creating a survey drawing. You want a band, a paper and a pencil for this. The finished drawing must not be too accurate, but the drive must be seen. A basic A4 sheet with a 1:50 scale displays the shape of your garage. You must indicate on the drawing from which power is supplied - possibly your power supply, but you can plan to procure it from a second source like a garage. If in doubt, ask an electrician if you can provide adequate power to your selected source. Then mark the streetlight on the spot you like. There are certain laws you must follow: this is an art form without a science. You must aim to have lights every six or 10 metres on the road for an ordinary double leading, three metre high street lighting device. If you keep the road lights on one side of the path, you save money because you must envelop the cable into ducts every time you cross the road, which are possibly surrounded by concrete in turn. A junction box, a precast manhole about 60cm deep, is required for any streetlight. The manufacturers may buy it from them. Assemble them about 100mm thick on a bed of concrete. They would like to be placed a metre or maybe one in a line from the streetlight. On either side of a ducted drive intersection, there should also be a junction box. You are now prepared to start installing lights on your driveway. Maybe you want to use a digger or maybe feel willing to catch it by hand. Take a trench (they are plain plastic, are about 5 cm in diameter and are available in rolls) - they have to be about 45 to 60 cm deep and about 30 cm long. Place the ducts (as well as the drawer inside) on a sand bed and cover with more sand about 10 cm deep around the cable. Restore the remainder of the trench with dirt. Take some trenches across the driveway but strive to make the bed on and around the concrete canals at a depth of 10-15 cm minimum 60 cm (and ideally more). Return the trench to the composition with graded stone (use concrete in case the quantity is little or perhaps if this presents a problem). Re-establish the driveway surface. Place the junction boxes on a concrete bed and lay a short duct for each streetlight in its actual placement. Make sure this pipeline continues about one metre above ground. Put around each vertical duct a concrete foundation (approximately 1m2) as the soil doesn't come from. These pillars are the road lights on which their position is crucial. Also to know more : Check Resin Driveways Brentwood Fix the street lighting bases to the concrete - this could include the piercing of the reinforcement of the concrete and inserting rag bolts, or even the application of the spreading resin and the use of bolts. Pull the real power cable through the ducts and chambers by means of the sketches. You can also decide to build a T joint in the chambers (if appropriate, it will be weatherproof) or you could choose to loop it over the streetlight. Get an electrician to do this bit, if in doubt. Join the cables in the road light base (very easy) and assemble other street light parts, like bulbs, if they are not currently there. Join the system eventually - a thing best left to a competent electrician who would maybe even look at your work on the others. Perhaps you would like to put a time check or a picture cell, so the lighting devices can only happen at certain times. We hope you appreciate the benefits of installing driveways. Something you do.